GATE 2014 ME Set 1 · Question 55
In a simple concentric shaft-bearing arrangement, the lubricant flows in the gap between the shaft and the bearing. The flow may be assumed to be a plane Couette flow with zero pressure gradient. The diameter of the shaft is and its tangential speed is . The dynamic viscosity of the lubricant is . The frictional resisting force (in newton) per length of the bearing is ________
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.45 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
For a plane Couette flow with zero pressure gradient in a small radial clearance, the velocity profile in the lubricant film is linear. The wall shear stress on the shaft surface is given by Newton's law of viscosity:
Given:
- Gap size
- Dynamic viscosity
- Tangential speed
Calculating the shear stress:
The surface area of the shaft over a length with diameter is:
The frictional resisting force is:
Answer: 15.71
Practise Laminar flow
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Laminar flow
- GATE 2014 ME Set 2 · Q53Water flows through a 10 mm diameter and 250 m long smooth pipe at an average velocity of 0.1 m/s. The…
- GATE 2014 ME Set 3 · Q55A fluid of dynamic viscosity 2 × 10-5 kg/m.s and density 1 kg/m3 flows with an average velocity of 1 m/s…
- GATE 2013 ME · Q7For steady, fully developed flow inside a straight pipe of diameter D, neglecting gravity effects, the…
- GATE 2025 ME · Q44For a fully-developed pipe flow, which of the following options is/are correct?
- GATE 2021 ME Set 1 · Q32Consider fully developed, steady state incompressible laminar flow of a viscous fluid between two large…
- GATE 2020 ME Set 1 · Q59Consider steady, viscous, fully developed flow of a fluid through a circular pipe of internal diameter D. We…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.