GATE 2014 ME Set 3 · Question 55
A fluid of dynamic viscosity and density flows with an average velocity of through a long duct of rectangular () cross-section. Assuming laminar flow, the pressure drop (in Pa) in the fully developed region per meter length of the duct is ________
GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.45 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The hydraulic diameter of the rectangular duct with cross-section and is:
The Reynolds number is:
Since , the flow is laminar. Using the Darcy friction factor approximation for laminar duct flow, :
The pressure drop per unit length () from the Darcy-Weisbach equation is:
*(Using the exact friction factor for an aspect ratio of , where , yields , which also falls in the range.)*
Answer: 1.82
Practise Laminar flow
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Laminar flow
- GATE 2013 ME · Q7For steady, fully developed flow inside a straight pipe of diameter D, neglecting gravity effects, the…
- GATE 2025 ME · Q44For a fully-developed pipe flow, which of the following options is/are correct?
- GATE 2021 ME Set 1 · Q32Consider fully developed, steady state incompressible laminar flow of a viscous fluid between two large…
- GATE 2020 ME Set 1 · Q59Consider steady, viscous, fully developed flow of a fluid through a circular pipe of internal diameter D. We…
- GATE 2019 ME Set 1 · Q55Two immiscible, incompressible, viscous fluids having same densities but different viscosities are contained…
- GATE 2019 ME Set 2 · Q33Water enters a circular pipe of length L = 5.0 m and diameter D = 0.20 m with Reynolds number ReD = 500. The…
Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.