GATE 2014 ME Set 1 · Question 61
A metal rod of initial length is subjected to a drawing process. The length of the rod at any instant is given by the expression, , where is the time in minutes. The true strain rate (in ) at the end of one minute is ________
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.51 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
True strain is defined as the natural logarithm of the ratio of instantaneous length to initial length:
The true strain rate is the time derivative of the true strain:
Substituting :
Answer: 1
Practise Mechanical Properties, Plastic Deformation and Yield Criteria
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanical Properties, Plastic Deformation and Yield Criteria
- GATE 2023 ME · Q57Ignoring the small elastic region, the true stress (sigma) – true strain (varepsilon) variation of a…
- GATE 2019 ME Set 1 · Q44A plane-strain compression (forging) of a block is shown in the figure. The strain in the z-direction is…
- GATE 2015 ME Set 3 · Q15The strain hardening exponent n of stainless steel SS 304 with distinct yield and UTS values undergoing…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.