GATE 2019 ME Set 1 · Question 44
A plane-strain compression (forging) of a block is shown in the figure. The strain in the -direction is zero. The yield strength () in uniaxial tension/compression of the material of the block is and it follows the Tresca (maximum shear stress) criterion. Assume that the entire block has started yielding. At a point where (compressive) and , the stress component is
- A
(compressive)
- B
(tensile)
- C
(compressive)
- D
(tensile)
GATE 2019 · Mechanical Engineering · Set 1 · IIT Madras · printed as Q.34 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
In plane-strain compression forging along the -direction:
- The moving platen compresses the block in the -direction, so is compressive (negative), with .
- Since , the normal stresses are principal stresses: .
For plane strain in the -direction (), rigid-plastic material flow dictates:
which is the intermediate principal stress.
According to the Tresca yield criterion, yielding occurs when the maximum shear stress reaches the shear yield strength:
Taking tensile stresses as positive:
Given and :
Thus, (compressive).
Answer: (A) (compressive)
Practise Mechanical Properties, Plastic Deformation and Yield Criteria
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanical Properties, Plastic Deformation and Yield Criteria
- GATE 2015 ME Set 3 · Q15The strain hardening exponent n of stainless steel SS 304 with distinct yield and UTS values undergoing…
- GATE 2014 ME Set 1 · Q61A metal rod of initial length L0 is subjected to a drawing process. The length of the rod at any instant is…
- GATE 2023 ME · Q57Ignoring the small elastic region, the true stress (sigma) – true strain (varepsilon) variation of a…
Question from the official GATE 2019 ME paper (Set 1), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.