GATE 2014 ME Set 1 · Question 62
During pure orthogonal turning operation of a hollow cylindrical pipe, it is found that the thickness of the chip produced is . The feed given to the zero degree rake angle tool is . The shear strain produced during the operation is ________
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.52 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In orthogonal turning, the uncut chip thickness is equal to the feed, , and the deformed chip thickness is .
The chip thickness ratio is:
For a zero rake angle (), the shear plane angle satisfies:
The shear strain produced in orthogonal cutting is given by:
Since :
Answer: 2.9
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2014 ME Set 3 · Q30A straight turning operation is carried out using a single point cutting tool on an AISI 1020 steel rod. The…
- GATE 2014 ME Set 3 · Q64Which pair of following statements is correct for orthogonal cutting using a single-point cutting tool? P.…
- GATE 2014 ME Set 4 · Q33Better surface finish is obtained with a large rake angle because
- GATE 2013 ME · Q52Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2013 ME · Q53Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2012 ME · Q27Details pertaining to an orthogonal metal cutting process are given below. | | | |---|---| | Chip thickness…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.