GATE 2014 ME Set 1 · Question 63
For the given assembly: , match Group A with Group B
| Group A | Group B |
| :--- | :--- |
| P. H | I. Shaft Type |
| Q. IT8 | II. Hole Type |
| R. IT7 | III. Hole Tolerance Grade |
| S. g | IV. Shaft Tolerance Grade |
- A
P-I, Q-III, R-IV, S-II
- B
P-I, Q-IV, R-III, S-II
- C
P-II, Q-III, R-IV, S-I
- D
P-II, Q-IV, R-III, S-I
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.53 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In the standard ISO system of limits and fits (e.g., ):
- Capital letters designate the fundamental deviation of a hole, so H represents the Hole Type (P-II).
- Lowercase letters designate the fundamental deviation of a shaft, so g represents the Shaft Type (S-I).
- The number following the capital letter indicates the International Tolerance (IT) grade of the hole, so IT7 is the Hole Tolerance Grade (R-III).
- The number following the lowercase letter indicates the IT grade of the shaft, so IT8 is the Shaft Tolerance Grade (Q-IV).
Matching these gives P-II, Q-IV, R-III, S-I.
Answer: (D) P-II, Q-IV, R-III, S-I
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2014 ME Set 4 · Q62A GO-No GO plug gauge is to be designed for measuring a hole of nominal diameter 25 mm with a hole tolerance…
- GATE 2013 ME · Q37Cylindrical pins of 25+0.020 mm diameter are electroplated in a shop. Thickness of the plating is 30 2.0…
- GATE 2012 ME · Q3In an interchangeable assembly, shafts of size 25.000-0.010+0.040 mm mate with holes of size…
- GATE 2025 ME · Q25When assembled, the hole 30+0.030+0.000 mm and shaft 30+0.020-0.020 mm will result in
- GATE 2022 ME Set 1 · Q20The type of fit between a mating shaft of diameter 25.0-0.010+0.010 mm and a hole of diameter…
- GATE 2022 ME Set 2 · Q20A shaft of diameter 25-0.07-0.04 mm is assembled in a hole of diameter 25-0.00+0.02 mm. Match the allowance…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.