GATE 2014 ME Set 2 · Question 58
In a concentric counter flow heat exchanger, water flows through the inner tube at and leaves at . The engine oil enters at and flows in the annular flow passage. The exit temperature of the engine oil is . Mass flow rate of water and the engine oil are 1.5 kg/s and 1 kg/s, respectively. The specific heat of water and oil are and , respectively. The effectiveness of this heat exchanger is _______
GATE 2014 · Mechanical Engineering · Set 2 · IIT Kharagpur · printed as Q.48 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
First, calculate the heat capacity rates of both fluids:
- Cold fluid (water):
- Hot fluid (engine oil):
Comparing the heat capacity rates:
The effectiveness of the heat exchanger is defined as the ratio of actual heat transfer rate to the maximum possible heat transfer rate:
Since :
Answer: 0.667
Practise Heat Exchangers: LMTD & Effectiveness-NTU Methods
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Heat Exchangers: LMTD & Effectiveness-NTU Methods
- GATE 2014 ME Set 3 · Q58A double-pipe counter-flow heat exchanger transfers heat between two water streams. Tube side water at 19…
- GATE 2012 ME · Q41Water (Cp = 4.18 kJ/kg.K) at 80°C enters a counterflow heat exchanger with a mass flow rate of 0.5 kg/s. Air…
- GATE 2026 ME · Q55Convective heat transfer coefficients for Fluid 1 and Fluid 2 in a heat exchanger, as shown in the figure…
- GATE 2024 ME · Q49A condenser is used as a heat exchanger in a large steam power plant in which steam is condensed to liquid…
- GATE 2023 ME · Q35Consider a counter-flow heat exchanger with the inlet temperatures of two fluids (1 and 2) being T1, in =…
- GATE 2022 ME Set 1 · Q65During open-heart surgery, a patient's blood is cooled down to 25 °C from 37 °C using a concentric tube…
Question from the official GATE 2014 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.