GATE 2012 ME · Question 41
Water () at enters a counterflow heat exchanger with a mass flow rate of . Air () enters at with a mass flow rate of . If the effectiveness of the heat exchanger is 0.8, the LMTD (in ) is
- A
40
- B
20
- C
10
- D
5
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
The heat capacity rates of the hot and cold fluids are:
Since , the capacity ratio is .
For a counterflow heat exchanger with equal heat capacity rates, the temperature difference between the streams is uniform along the length, so .
The actual heat transfer rate is:
The exit temperatures are:
The temperature differences at the two ends are:
Therefore, the log mean temperature difference is .
Answer: (C)
Practise Heat Exchangers: LMTD & Effectiveness-NTU Methods
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Heat Exchangers: LMTD & Effectiveness-NTU Methods
- GATE 2026 ME · Q55Convective heat transfer coefficients for Fluid 1 and Fluid 2 in a heat exchanger, as shown in the figure…
- GATE 2024 ME · Q49A condenser is used as a heat exchanger in a large steam power plant in which steam is condensed to liquid…
- GATE 2023 ME · Q35Consider a counter-flow heat exchanger with the inlet temperatures of two fluids (1 and 2) being T1, in =…
- GATE 2022 ME Set 1 · Q65During open-heart surgery, a patient's blood is cooled down to 25 °C from 37 °C using a concentric tube…
- GATE 2022 ME Set 2 · Q64Saturated vapor at 200 °C condenses to saturated liquid at the rate of 150 kg/s on the shell side of a heat…
- GATE 2021 ME Set 2 · Q54A shell and tube heat exchanger is used as a steam condenser. Coolant water enters the tube at 300 K at a…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.