GATE 2014 ME Set 3 · Question 21
Gear 2 rotates at 1200 rpm in counter clockwise direction and engages with Gear 3. Gear 3 and Gear 4 are mounted on the same shaft. Gear 5 engages with Gear 4. The numbers of teeth on Gears 2, 3, 4 and 5 are 20, 40, 15 and 30, respectively. The angular speed of Gear 5 is
- A
300 rpm counterclockwise
- B
300 rpm clockwise
- C
4800 rpm counterclockwise
- D
4800 rpm clockwise
GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.11 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
For two externally meshing gears and , the speed ratio and direction are given by:
where the negative sign indicates opposite directions of rotation.
Gear 2 drives Gear 3 externally:
Gear 4 is mounted on the same shaft as Gear 3, so:
Gear 4 drives Gear 5 externally:
The positive sign indicates counterclockwise rotation. Thus, Gear 5 rotates at counterclockwise.
Answer: (A) 300 rpm counterclockwise
Practise Gears and Gear Trains
20 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Gears and Gear Trains
- GATE 2014 ME Set 4 · Q18Which one of the following is used to convert a rotational motion into a translational motion?
- GATE 2014 ME Set 4 · Q43It is desired to avoid interference in a pair of spur gears having a 20° pressure angle. With increase in…
- GATE 2013 ME · Q32A compound gear train with gears P, Q, R and S has number of teeth 20, 40, 15 and 20, respectively. Gears Q…
- GATE 2012 ME · Q8The following are the data for two crossed helical gears used for speed reduction: Gear I : Pitch circle…
- GATE 2026 ME · Q17A gear train with five gears is shown in the figure below. The number of teeth on each gear is N1, N2, N3,…
- GATE 2026 ME · Q22Worm gearsets are used for transmitting rotary motion between
Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.