GATE 2014 ME Set 3 · Question 22
Consider a long cylindrical tube of inner and outer radii, and , respectively, length, and thermal conductivity, . Its inner and outer surfaces are maintained at and , respectively (). Assuming one-dimensional steady state heat conduction in the radial direction, the thermal resistance in the wall of the tube is
- A
- B
- C
- D
GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.12 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
For steady-state, one-dimensional radial heat conduction through a hollow cylinder with no internal heat generation, Fourier's law of heat conduction states:
Separating variables and integrating between the inner surface (, ) and the outer surface (, ):
Rearranging in the form of thermal Ohm's law, :
Answer: (C)
Practise 1D Steady Conduction, Resistance & Critical Insulation
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from 1D Steady Conduction, Resistance & Critical Insulation
- GATE 2014 ME Set 3 · Q54Heat transfer through a composite wall is shown in figure. Both the sections of the wall have equal…
- GATE 2014 ME Set 4 · Q52A plane wall has a thermal conductivity of 1.15 W/m.K. If the inner surface is at 1100°C and the outer…
- GATE 2022 ME Set 1 · Q60Consider a one-dimensional steady heat conduction process through a solid slab of thickness 0.1 m. The…
- GATE 2022 ME Set 1 · Q64Consider a solid slab (thermal conductivity, k = 10 W×m-1×K-1) with thickness 0.2 m and of infinite extent…
- GATE 2021 ME Set 1 · Q53An uninsulated cylindrical wire of radius 1.0 mm produces electric heating at the rate of 5.0 W/m. The…
- GATE 2020 ME Set 2 · Q34In a furnace, the inner and outer sides of the brick wall (k1 = 2.5 W/m.K) are maintained at 1100°C and…
Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.