GATE 2021 ME Set 2 · Question 64
The torque provided by an engine is given by , where is the angle turned by the crank from inner dead center. The mean speed of the engine is and it drives a machine that provides a constant resisting torque. If variation of the speed from the mean speed is not to exceed , the minimum mass moment of inertia of the flywheel should be \_\_\_\_\_\_\_\_\_\_\_ *(round off to the nearest integer)*.
GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.54 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
Given the engine torque:
The mean torque is . The maximum fluctuation of energy corresponds to the area of one loop of the torque curve above the mean line:
The mean angular speed is:
The coefficient of fluctuation of speed for a variation of is:
The required mass moment of inertia is:
Answer: 570
Practise Flywheels and Turning Moment Diagrams
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Flywheels and Turning Moment Diagrams
- GATE 2020 ME Set 1 · Q30A flywheel is attached to an engine to keep its rotational speed between 100 rad/s and 110 rad/s. If the…
- GATE 2020 ME Set 2 · Q49The turning moment diagram of a flywheel fitted to a fictitious engine is shown in the figure. The mean…
- GATE 2015 ME Set 3 · Q12For the same material and the mass, which of the following configurations of flywheel will have maximum mass…
- GATE 2015 ME Set 3 · Q57The torque (in N-m) exerted on the crank shaft of a two stroke engine can be described as T = 10000 + 1000…
- GATE 2014 ME Set 2 · Q47Maximum fluctuation of kinetic energy in an engine has been calculated to be 2600 J. Assuming that the…
- GATE 2014 ME Set 4 · Q48Torque and angular speed data over one cycle for a shaft carrying a flywheel are shown in the figures. The…
Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.