GATE 2015 ME Set 1 · Question 21
Air enters a diesel engine with a density of . The compression ratio is 21. At steady state, the air intake is and the net work output is . The mean effective pressure (in kPa) is
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The volume flow rate of air intake is given by:
The total cylinder volume is , and the compression ratio is .
The displaced volume (swept volume) flow rate is related to by:
The mean effective pressure () is defined as the net work output per unit swept volume:
Answer: 525
Practise Air-Standard IC Engine Cycles (Otto, Diesel, Dual)
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Air-Standard IC Engine Cycles (Otto, Diesel, Dual)
- GATE 2015 ME Set 2 · Q56For the same values of peak pressure, peak temperature and heat rejection, the correct order of efficiencies…
- GATE 2015 ME Set 3 · Q35An air-standard Diesel cycle consists of the following processes: 1-2: Air is compressed isentropically.…
- GATE 2014 ME Set 1 · Q57In an air-standard Otto cycle, air is supplied at 0.1 MPa and 308 K. The ratio of the specific heats (γ) and…
- GATE 2014 ME Set 3 · Q59A diesel engine has a compression ratio of 17 and cut-off takes place at 10% of the stroke. Assuming ratio…
- GATE 2014 ME Set 4 · Q59In a compression ignition engine, the inlet air pressure is 1 bar and the pressure at the end of isentropic…
- GATE 2025 ME · Q32The thermal efficiency of an ideal air-standard Otto cycle is 0.5. The value of specific heat ratio of air…
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.