GATE 2015 ME Set 1 · Question 60
A diameter electrical conductor is covered by an insulation of thickness. The conductivity of the insulation is and the convection coefficient at the insulation surface is . Addition of further insulation of the same material will
- A
increase heat loss continuously
- B
decrease heat loss continuously
- C
increase heat loss to a maximum and then decrease heat loss
- D
decrease heat loss to a minimum and then increase heat loss
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The conductor has a radius of:
With an insulation thickness of , the current outer radius of the insulation is:
The critical radius of insulation for a cylinder is given by:
Because the present outer radius is less than the critical radius , adding more insulation increases the outer radius towards , which reduces the total thermal resistance and increases the rate of heat loss until (where heat loss is maximum). Increasing the radius beyond causes the conduction resistance to dominate, thus decreasing the heat loss.
Answer: (C) increase heat loss to a maximum and then decrease heat loss
Practise 1D Steady Conduction, Resistance & Critical Insulation
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from 1D Steady Conduction, Resistance & Critical Insulation
- GATE 2015 ME Set 2 · Q25If a foam insulation is added to a 4 cm outer diameter pipe as shown in the figure, the critical radius of…
- GATE 2015 ME Set 3 · Q64A brick wall (k = 0.9W/m.K ) of thickness 0.18 m separates the warm air in a room from the cold ambient air.…
- GATE 2014 ME Set 1 · Q52Consider one dimensional steady state heat conduction across a wall (as shown in figure below) of thickness…
- GATE 2014 ME Set 2 · Q54A material P of thickness 1 mm is sandwiched between two steel slabs, as shown in the figure below. A heat…
- GATE 2014 ME Set 3 · Q22Consider a long cylindrical tube of inner and outer radii, ri and ro, respectively, length, L and thermal…
- GATE 2014 ME Set 3 · Q54Heat transfer through a composite wall is shown in figure. Both the sections of the wall have equal…
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.