GATE 2015 ME Set 2 · Question 25
If a foam insulation is added to a outer diameter pipe as shown in the figure, the critical radius of insulation (in cm) is ________
GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The critical radius of insulation for a cylinder depends only on the thermal conductivity of the insulating material () and the outer convective heat transfer coefficient ():
From the given figure:
- Thermal conductivity of foam,
- Outer heat transfer coefficient,
Substituting these values:
Note that the pipe diameter, inner convective coefficient , and pipe conductivity do not affect the critical radius of the outer insulation.
Answer: 5
Practise 1D Steady Conduction, Resistance & Critical Insulation
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from 1D Steady Conduction, Resistance & Critical Insulation
- GATE 2015 ME Set 3 · Q64A brick wall (k = 0.9W/m.K ) of thickness 0.18 m separates the warm air in a room from the cold ambient air.…
- GATE 2014 ME Set 1 · Q52Consider one dimensional steady state heat conduction across a wall (as shown in figure below) of thickness…
- GATE 2014 ME Set 2 · Q54A material P of thickness 1 mm is sandwiched between two steel slabs, as shown in the figure below. A heat…
- GATE 2014 ME Set 3 · Q22Consider a long cylindrical tube of inner and outer radii, ri and ro, respectively, length, L and thermal…
- GATE 2014 ME Set 3 · Q54Heat transfer through a composite wall is shown in figure. Both the sections of the wall have equal…
- GATE 2014 ME Set 4 · Q52A plane wall has a thermal conductivity of 1.15 W/m.K. If the inner surface is at 1100°C and the outer…
Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.