GATE 2015 ME Set 2 · Question 48
2 marksMultiple choiceMechanics of MaterialsTorsion of Circular Shafts
A hollow shaft ( where and are the outer and inner diameters respectively) needs to transmit power at . If the maximum permissible shear stress is , is
- A
- B
- C
- D
GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur
Answer
(B)
From the official answer key published by IIT Kanpur.
Worked solution
The torque transmitted by the shaft is:
The torsional shear stress in a hollow shaft with ratio is:
Here, .
Substituting :
Answer: (B) 22.58 mm
Practise Torsion of Circular Shafts
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Torsion of Circular Shafts
- GATE 2014 ME Set 3 · Q17Two solid circular shafts of radii R1 and R2 are subjected to same torque. The maximum shear stresses…
- GATE 2023 ME · Q60A cylindrical transmission shaft of length 1.5 m and diameter 100 mm is made of a linear elastic material…
- GATE 2022 ME Set 2 · Q50A shaft of length L is made of two materials, one in the inner core and the other in the outer rim, and the…
- GATE 2019 ME Set 1 · Q30A cylindrical rod of diameter 10 mm and length 1.0 m is fixed at one end. The other end is twisted by an…
- GATE 2018 ME Set 2 · Q30A hollow circular shaft of inner radius 10 mm, outer radius 20 mm and length 1 m is to be used as a…
- GATE 2018 ME Set 2 · Q41A bar of circular cross section is clamped at ends P and Q as shown in the figure. A torsional moment T =…
Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.