GATE 2015 ME Set 3 · Question 39
The number of degrees of freedom of the linkage shown in the figure is
- A
- B
- C
- D
GATE 2015 · Mechanical Engineering · Set 3 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
To find the degrees of freedom (mobility) of the planar linkage, we apply Kutzbach's criterion:
where is the number of links, is the number of lower pairs (single degree of freedom joints), and is the number of higher pairs.
From the given figure:
1. Links ():
- Fixed link (ground)
- Left ternary link (triangular plate)
- Top and bottom connecting rods (binary links)
- Right ternary link (triangular plate)
- Rightmost crank/rocker (binary link)
2. Joints (, all simple revolute/pin joints):
- Ground to left ternary link
- Left ternary link to top and bottom binary links (2 joints)
- Top and bottom binary links to right ternary link (2 joints)
- Right ternary link to right binary link (1 joint)
- Right binary link to ground (1 joint)
3. Higher pairs (): None present.
Substituting these values into Kutzbach's criterion:
Thus, the linkage is a constrained mechanism with degree of freedom.
Answer: (C)
Practise Planar Mechanisms, Mobility and Inversions
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Planar Mechanisms, Mobility and Inversions
- GATE 2014 ME Set 1 · Q20For the given statements: I. Mating spur gear teeth is an example of higher pair II. A revolute joint is an…
- GATE 2014 ME Set 1 · Q47An offset slider-crank mechanism is shown in the figure at an instant. Conventionally, the Quick Return…
- GATE 2014 ME Set 2 · Q18A 4-bar mechanism with all revolute pairs has link lengths lf = 20 mm, lin = 40 mm, lco = 50 mm and lout =…
- GATE 2013 ME · Q23A planar closed kinematic chain is formed with rigid links PQ = 2.0 m, QR = 3.0 m, RS = 2.5 m and SP = 2.7 m…
- GATE 2025 ME · Q60An offset slider-crank mechanism is shown in the figure below. The length of the stroke of the slider is…
- GATE 2022 ME Set 1 · Q38A planar four-bar linkage mechanism with 3 revolute kinematic pairs and 1 prismatic kinematic pair is shown…
Question from the official GATE 2015 ME paper (Set 3), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.