PARIXO GATE · ME Open the app

GATE 2016 ME Set 1 · Question 45

2 marksNumerical answerTheory of MachinesDynamic Force Analysis of Linkages

A slider crank mechanism with crank radius 200 mm and connecting rod length 800 mm is shown. The crank is rotating at 600 rpm in the counterclockwise direction. In the configuration shown, the crank makes an angle of with the sliding direction of the slider, and a force of 5 kN is acting on the slider. Neglecting the inertia forces, the turning moment on the crank (in kN-m) is ________

Figure 1 for GATE 2016 ME Set 1 question 45

GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.35 in the ME section

Answer
0.9 to 1.1

From the official answer key published by IISc Bangalore.

Worked solution

By the principle of virtual work, neglecting friction and inertia forces, the instantaneous input power equals the output power:

where is the turning moment on the crank, is the crank angular velocity, is the force on the slider, and is the slider velocity.

The velocity of the slider at any crank angle (measured from the line of stroke) is given by:

where , , and .

For the given configuration, the crank is perpendicular to the sliding direction, so :

Substituting into the power balance equation:

Answer: 1.0

Practise Dynamic Force Analysis of Linkages

7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Dynamic Force Analysis of Linkages

Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.