GATE 2016 ME Set 3 · Question 31
Equal amounts of a liquid metal at the same temperature are poured into three moulds made of steel, copper and aluminum. The shape of the cavity is a cylinder with 15 mm diameter. The size of the moulds are such that the outside temperature of the moulds do not increase appreciably beyond the atmospheric temperature during solidification. The sequence of solidification in the mould from the fastest to slowest is
(Thermal conductivities of steel, copper and aluminum are 60.5, 401 and 237 W/m-K, respectively. Specific heats of steel, copper and aluminum are 434, 385 and 903 J/kg-K, respectively. Densities of steel, copper and aluminum are 7854, 8933 and 2700 , respectively.)
- A
Copper - Steel - Aluminum
- B
Aluminum - Steel - Copper
- C
Copper - Aluminum - Steel
- D
Steel - Copper - Aluminum
GATE 2016 · Mechanical Engineering · Set 3 · IISc Bangalore · printed as Q.21 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
When a molten metal solidifies in a thick mould where the outer surface temperature does not rise appreciably, the heat transfer is governed by transient conduction into a semi-infinite solid. The rate of heat absorption by the mould is directly proportional to its thermal effusivity (or heat diffusivity) :
A higher effusivity implies a faster rate of heat extraction, and consequently a faster solidification time. Calculating for each mould material:
1. Copper:
2. Aluminum:
3. Steel:
Since , the rate of cooling is highest in copper, followed by aluminum, and slowest in steel. Thus, the solidification sequence from fastest to slowest is Copper - Aluminum - Steel.
Answer: (C) Copper - Aluminum - Steel
Practise Casting: Patterns, Moulds, Gating and Solidification
34 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Casting: Patterns, Moulds, Gating and Solidification
- GATE 2015 ME Set 1 · Q46The solidification time of a casting is proportional to (V/A )2, where V is the volume of the casting and A…
- GATE 2015 ME Set 2 · Q58A cube and a sphere made of cast iron (each of volume 1000 cm3) were cast under identical conditions. The…
- GATE 2015 ME Set 3 · Q17In full mould (cavity-less) casting process, the pattern is made of
- GATE 2015 ME Set 3 · Q42Ratio of solidification time of a cylindrical casting (height = radius) to that of a cubic casting of side…
- GATE 2015 ME Set 3 · Q60The dimensions of a cylindrical side riser (height = diameter) for a 25 cm × 15 cm × 5 cm steel casting are…
- GATE 2014 ME Set 1 · Q65An aluminium alloy (density 2600 kg/m3) casting is to be produced. A cylindrical hole of 100 mm diameter and…
Question from the official GATE 2016 ME paper (Set 3), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.