GATE 2016 ME Set 3 · Question 33
1 markMultiple choiceManufacturing EngineeringBasic Machine Tools and Operations
Internal gears are manufactured by
- A
hobbing
- B
shaping with pinion cutter
- C
shaping with rack cutter
- D
milling
GATE 2016 · Mechanical Engineering · Set 3 · IISc Bangalore · printed as Q.23 in the ME section
Answer
(B)
From the official answer key published by IISc Bangalore.
Worked solution
Internal gears have teeth on the inside surface of a cylinder or cone.
- Gear shaping with a pinion cutter can easily access the internal diameter because the cutter reciprocates inside the blank while rotating in mesh with it. Hence, it is widely used to cut internal spur and helical gears.
- Gear hobbing cannot generate internal teeth without specialized and highly constrained attachments because the hob arbor interferes with the blank's internal rim.
- Rack cutters and conventional milling cutters also suffer from severe tool interference or clearance limitations when machining internal teeth.
Therefore, internal gears are typically manufactured by shaping using a pinion cutter or by broaching.
Answer: (B) shaping with pinion cutter
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2015 ME Set 3 · Q16In a machining operation, if the generatrix and directrix both are straight lines, the surface obtained is
- GATE 2015 ME Set 3 · Q59A shaft of length 90 mm has a tapered portion of length 55 mm. The diameter of the taper is 80 mm at one end…
- GATE 2014 ME Set 2 · Q32Match the Machine Tools (Group A) with the probable Operations (Group B): | Group A | Group B | | :--- |…
- GATE 2014 ME Set 2 · Q64A hole of 20 mm diameter is to be drilled in a steel block of 40 mm thickness. The drilling is performed at…
- GATE 2014 ME Set 4 · Q31Two separate slab milling operations, 1 and 2, are performed with identical milling cutters. The depth of…
- GATE 2014 ME Set 4 · Q64A cast iron block of 200 mm length is being shaped in a shaping machine with a depth of cut of 4 mm, feed of…
Question from the official GATE 2016 ME paper (Set 3), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.