GATE 2017 ME Set 2 · Question 17
Consider a laminar flow at zero incidence over a flat plate. The shear stress at the wall is denoted by . The axial positions and on the plate are measured from the leading edge in the direction of flow. If , then
- A
- B
- C
- D
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
For laminar boundary layer flow over a flat plate at zero incidence (Blasius solution), the boundary layer thickness grows as .
The local skin friction coefficient and the wall shear stress are given by:
Since wall shear stress is inversely proportional to the square root of the distance from the leading edge (), as the distance increases, the velocity gradient at the wall decreases.
Given that , it directly follows that:
Answer: (C)
Practise Boundary layer and separation
12 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Boundary layer and separation
- GATE 2016 ME Set 1 · Q51A steady laminar boundary layer is formed over a flat plate as shown in the figure. The free stream velocity…
- GATE 2015 ME Set 1 · Q17The Blasius equation related to boundary layer theory is a
- GATE 2015 ME Set 1 · Q62Air (ρ = 1.2 kg/m3 and kinematic viscosity, = 2 × 10-5 m2/s) with a velocity of 2 m/s flows over the top…
- GATE 2015 ME Set 2 · Q24Within a boundary layer for a steady incompressible flow, the Bernoulli equation
- GATE 2014 ME Set 2 · Q55Consider laminar flow of water over a flat plate of length 1 m. If the boundary layer thickness at a…
- GATE 2012 ME · Q30An incompressible fluid flows over a flat plate with zero pressure gradient. The boundary layer thickness is…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.