PARIXO GATE · ME Open the app

GATE 2017 ME Set 2 · Question 32

2 marksNumerical answerTheory of MachinesGears and Gear Trains

A gear train shown in the figure consists of gears P, Q, R and S. Gear Q and gear R are mounted on the same shaft. All the gears are mounted on parallel shafts and the number of teeth of P, Q, R and S are 24, 45, 30 and 80, respectively. Gear P is rotating at . The speed (in rpm) of the gear S is ________

Figure 1 for GATE 2017 ME Set 2 question 32

GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee

Answer
119 to 121

From the official answer key published by IIT Roorkee.

Worked solution

From the given schematic:

  • Gear P meshes with the outer gear Q.
  • Gear S also meshes with the outer gear Q at the opposite pitch point.
  • Gear R is mounted on the same intermediate shaft but does not engage with either gear P or gear S.

Therefore, gear Q acts as an intermediate idler gear between gear P and gear S.

The speed ratio between gear P (driver) and gear S (driven) is independent of the number of teeth on the idler gear Q:

Given:

  • Speed of gear P:
  • Number of teeth on gear P:
  • Number of teeth on gear S:

Substituting the values:

Answer: 120

Practise Gears and Gear Trains

20 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Gears and Gear Trains

Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.