GATE 2017 ME Set 2 · Question 37
The principal stresses at a point in a critical section of a machine component are , and . For the material of the component, the tensile yield strength is . According to the maximum shear stress theory, the factor of safety is
- A
1.67
- B
2.00
- C
3.60
- D
4.00
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
According to the maximum shear stress theory (Tresca's criterion), yielding occurs when the maximum shear stress reaches the shear yield strength .
The given principal stresses are:
The maximum shear stress is:
The factor of safety (FOS) is given by:
Substituting :
Thus, option (B) is correct, while options (A), (C), and (D) result from neglecting the intermediate stress or calculating with incorrect principal stress pairs.
Answer: (B) 2.00
Practise Energy Methods and Theories of Failure
21 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Energy Methods and Theories of Failure
- GATE 2015 ME Set 1 · Q53A machine element is subjected to the following bi-axial state of stress: σx = 80 MPa; σy = 20 MPa; τxy = 40…
- GATE 2015 ME Set 2 · Q21The uniaxial yield stress of a material is 300 MPa. According to von Mises criterion, the shear yield stress…
- GATE 2014 ME Set 2 · Q48Consider the two states of stress as shown in configurations I and II in the figure below. From the…
- GATE 2014 ME Set 3 · Q20Which one of following is NOT correct?
- GATE 2014 ME Set 4 · Q46A frame is subjected to a load P as shown in the figure. The frame has a constant flexural rigidity EI. The…
- GATE 2013 ME · Q5Two threaded bolts A and B of same material and length are subjected to identical tensile load. If the…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.