GATE 2017 ME Set 2 · Question 39
The arrangement shown in the figure measures the velocity of a gas of density flowing through a pipe. The acceleration due to gravity is . If the manometric fluid is water (density ) and the velocity is , the differential head (in mm) between the two arms of the manometer is ________
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The Pitot-static tube arrangement measures the dynamic pressure of the gas stream:
where is the stagnation pressure, is the static pressure, , and .
The differential pressure is balanced by the manometer fluid column:
where and .
Equating the two expressions:
If the gas density in the manometer equation is neglected ():
Both values lie well within the official range of 19 to 21 mm.
Answer: 20.4
Practise Fluid dynamics and flow measurement
20 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Fluid dynamics and flow measurement
- GATE 2015 ME Set 1 · Q63Water (ρ = 1000 kg/m3) flows through a venturimeter with inlet diameter 80 mm and throat diameter 40 mm. The…
- GATE 2015 ME Set 3 · Q46A Prandtl tube (Pitot-static tube with C=1) is used to measure the velocity of water. The differential…
- GATE 2014 ME Set 3 · Q53A siphon is used to drain water from a large tank as shown in the figure below. Assume that the level of…
- GATE 2013 ME · Q29Water is coming out from a tap and falls vertically downwards. At the tap opening, the stream diameter is 20…
- GATE 2012 ME · Q40A large tank with a nozzle attached contains three immiscible, inviscid fluids as shown. Assuming that the…
- GATE 2026 ME · Q24A steady incompressible laminar flow passes through a 90° tube bend placed on a horizontal surface. In…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.