GATE 2017 ME Set 2 · Question 46
In a counter-flow heat exchanger, water is heated at the rate of from to by an oil entering at and leaving at . The specific heats of water and oil are and , respectively. The overall heat transfer coefficient is . The required heat transfer surface area (in ) is
- A
0.104
- B
0.022
- C
10.4
- D
21.84
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The rate of heat transfer from water is:
For a counter-flow heat exchanger, the temperature differences at the two ends are:
The Logarithmic Mean Temperature Difference (LMTD) is:
The required heat transfer area is:
Answer: (D) 21.84
Practise Heat Exchangers: LMTD & Effectiveness-NTU Methods
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Heat Exchangers: LMTD & Effectiveness-NTU Methods
- GATE 2016 ME Set 2 · Q52Consider a parallel-flow heat exchanger with area Ap and a counter-flow heat exchanger with area Ac. In both…
- GATE 2016 ME Set 3 · Q28For a heat exchanger, Δ T is the maximum temperature difference and Δ T is the minimum temperature…
- GATE 2015 ME Set 2 · Q52A balanced counterflow heat exchanger has a surface area of 20 m2 and overall heat transfer coefficient of…
- GATE 2015 ME Set 3 · Q22Saturated vapor is condensed to saturated liquid in a condenser. The heat capacity ratio is Cr = C C . The…
- GATE 2014 ME Set 2 · Q26In a heat exchanger, it is observed that Δ T1 = Δ T2, where Δ T1 is the temperature difference between the…
- GATE 2014 ME Set 2 · Q58In a concentric counter flow heat exchanger, water flows through the inner tube at 25°C and leaves at 42°C.…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.