GATE 2019 ME Set 1 · Question 35
Consider the stress-strain curve for an ideal elastic-plastic strain hardening metal as shown in the figure. The metal was loaded in uniaxial tension starting from O. Upon loading, the stress-strain curve passes through initial yield point at P, and then strain hardens to point Q, where the loading was stopped. From point Q, the specimen was unloaded to point R, where the stress is zero. If the same specimen is reloaded in tension from point R, the value of stress at which the material yields again is _____ MPa.
GATE 2019 · Mechanical Engineering · Set 1 · IIT Madras · printed as Q.25 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
When a metal undergoes plastic deformation with strain hardening, its yield strength increases due to the accumulation and interaction of dislocations.
1. Initial loading along path is linearly elastic until the initial yield point is reached at a stress of .
2. Further loading along path causes plastic deformation accompanied by strain hardening up to point , where the stress reaches .
3. Upon unloading along path , the material unloads elastically with a slope equal to Young's modulus, leaving a permanent plastic strain at .
4. When the specimen is reloaded in tension from point , it deforms elastically along the unloading line until it reaches point .
Therefore, yielding begins again at the maximum stress previously attained during loading, which is .
Answer: 210
Practise Testing of Materials: UTM, Hardness and Impact
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Testing of Materials: UTM, Hardness and Impact
- GATE 2019 ME Set 1 · Q51In a UTM experiment, a sample of length 100 mm, was loaded in tension until failure. The failure load was 40…
- GATE 2018 ME Set 1 · Q21In a linearly hardening plastic material, the true stress beyond initial yielding
- GATE 2018 ME Set 1 · Q58The true stress (σ) - true strain ( ) diagram of a strain hardening material is shown in figure. First,…
- GATE 2018 ME Set 2 · Q56The true stress (in MPa) versus true strain relationship for a metal is given by σ = 1020 0.4. The…
- GATE 2017 ME Set 1 · Q25In the engineering stress-strain curve for mild steel, the Ultimate Tensile Strength (UTS) refers to
- GATE 2016 ME Set 1 · Q58A hypothetical engineering stress-strain curve shown in the figure has three straight lines PQ, QR, RS with…
Question from the official GATE 2019 ME paper (Set 1), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.