GATE 2016 ME Set 1 · Question 58
A hypothetical engineering stress-strain curve shown in the figure has three straight lines PQ, QR, RS with coordinates P(0,0), Q(0.2,100), R(0.6,140) and S(0.8,130). 'Q' is the yield point, 'R' is the UTS point and 'S' the fracture point.
The toughness of the material (in ) is ________
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.48 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The modulus of toughness is the total area under the engineering stress-strain curve up to the fracture point .
Note that the engineering strain is given in percent:
Calculating the area of each segment:
1. Triangle under :
2. Trapezoid under :
3. Trapezoid under :
Total toughness:
Answer: 0.85
Practise Testing of Materials: UTM, Hardness and Impact
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Testing of Materials: UTM, Hardness and Impact
- GATE 2015 ME Set 1 · Q30Which one of the following types of stress-strain relationship best describes the behaviour of brittle…
- GATE 2015 ME Set 2 · Q60The flow stress (in MPa) of a material is given by σ = 500 0.1, where is true strain. The Young's modulus of…
- GATE 2014 ME Set 3 · Q34The stress-strain curve for mild steel is shown in the figure given below. Choose the correct option…
- GATE 2013 ME · Q17For a ductile material, toughness is a measure of
- GATE 2022 ME Set 2 · Q16Which one of the following is the definition of ultimate tensile strength (UTS) obtained from a…
- GATE 2021 ME Set 1 · Q16The loading and unloading response of a metal is shown in the figure. The elastic and plastic strains…
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.