GATE 2018 ME Set 2 · Question 56
The true stress (in MPa) versus true strain relationship for a metal is given by
The cross-sectional area at the start of a test (when the stress and strain values are equal to zero) is . The cross-sectional area at the time of necking (in ) is ________ (correct to two decimal places)
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.46 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
According to Considère's criterion for necking in a tensile test under the power-law hardening relation :
Given , we have . Thus, necking begins at a true strain of:
Assuming constant volume (incompressibility of plastic deformation):
The true strain is defined as:
Therefore, at the onset of necking:
Given the initial area :
Answer: 67.03
Practise Testing of Materials: UTM, Hardness and Impact
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Testing of Materials: UTM, Hardness and Impact
- GATE 2017 ME Set 1 · Q25In the engineering stress-strain curve for mild steel, the Ultimate Tensile Strength (UTS) refers to
- GATE 2016 ME Set 1 · Q58A hypothetical engineering stress-strain curve shown in the figure has three straight lines PQ, QR, RS with…
- GATE 2015 ME Set 1 · Q30Which one of the following types of stress-strain relationship best describes the behaviour of brittle…
- GATE 2015 ME Set 2 · Q60The flow stress (in MPa) of a material is given by σ = 500 0.1, where is true strain. The Young's modulus of…
- GATE 2014 ME Set 3 · Q34The stress-strain curve for mild steel is shown in the figure given below. Choose the correct option…
- GATE 2013 ME · Q17For a ductile material, toughness is a measure of
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.