GATE 2019 ME Set 1 · Question 51
In a UTM experiment, a sample of length , was loaded in tension until failure. The failure load was . The displacement, measured using the cross-head motion, at failure, was . The compliance of the UTM is constant and is given by . The strain at failure in the sample is ________%.
GATE 2019 · Mechanical Engineering · Set 1 · IIT Madras · printed as Q.41 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
The total displacement measured by the cross-head motion () is the sum of the specimen elongation () and the deflection of the testing machine ():
The deformation of the UTM due to its compliance under the failure load is:
Given the total cross-head displacement at failure , the actual elongation of the sample at failure is:
With an initial sample length , the engineering strain at failure is:
Answer: 13
Practise Testing of Materials: UTM, Hardness and Impact
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Testing of Materials: UTM, Hardness and Impact
- GATE 2018 ME Set 1 · Q21In a linearly hardening plastic material, the true stress beyond initial yielding
- GATE 2018 ME Set 1 · Q58The true stress (σ) - true strain ( ) diagram of a strain hardening material is shown in figure. First,…
- GATE 2018 ME Set 2 · Q56The true stress (in MPa) versus true strain relationship for a metal is given by σ = 1020 0.4. The…
- GATE 2017 ME Set 1 · Q25In the engineering stress-strain curve for mild steel, the Ultimate Tensile Strength (UTS) refers to
- GATE 2016 ME Set 1 · Q58A hypothetical engineering stress-strain curve shown in the figure has three straight lines PQ, QR, RS with…
- GATE 2015 ME Set 1 · Q30Which one of the following types of stress-strain relationship best describes the behaviour of brittle…
Question from the official GATE 2019 ME paper (Set 1), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.