GATE 2019 ME Set 2 · Question 24
Hardenability of steel is a measure of
- A
the ability to harden when it is cold worked
- B
the maximum hardness that can be obtained when it is austenitized and then quenched
- C
the depth to which required hardening is obtained when it is austenitized and then quenched
- D
the ability to retain its hardness when it is heated to elevated temperatures
GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.14 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
Hardenability is the property that determines the depth and distribution of hardness induced by quenching from the austenitizing temperature. It is primarily evaluated using the Jominy end-quench test.
- It should not be confused with hardness, which is the resistance to indentation or scratching, or the maximum hardness attainable (which depends almost entirely on the carbon content, described in option B).
- The ability to harden during plastic deformation (Option A) is known as *strain hardening* or *work hardening*.
- The retention of hardness at elevated temperatures (Option D) refers to *hot hardness* or *red hardness*.
Therefore, hardenability represents the depth to which a required level of hardness is obtained upon quenching.
Answer: (C) the depth to which required hardening is obtained when it is austenitized and then quenched
Practise Phase Diagrams and Heat Treatment
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Phase Diagrams and Heat Treatment
- GATE 2019 ME Set 2 · Q44The binary phase diagram of metals P and Q is shown in the figure. An alloy X containing 60% P and 40% Q (by…
- GATE 2018 ME Set 2 · Q22Denoting L as liquid and M as solid in a phase-diagram with the subscripts representing different phases, a…
- GATE 2017 ME Set 2 · Q22Given the atomic weight of Fe is 56 and that of C is 12, the weight percentage of carbon in cementite (…
- GATE 2016 ME Set 1 · Q30The "Jominy test" is used to find
- GATE 2016 ME Set 2 · Q31In the phase diagram shown in the figure, four samples of the same composition are heated to temperatures…
- GATE 2016 ME Set 2 · Q58In a binary system of A and B, a liquid of 20% A (80% B) is coexisting with a solid of 70% A (30% B). For an…
Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.