GATE 2019 ME Set 2 · Question 25
The fluidity of molten metal of cast alloys (without any addition of fluxes) increases with increase in
- A
viscosity
- B
surface tension
- C
freezing range
- D
degree of superheat
GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.15 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
Fluidity refers to the capability of molten metal to flow and fill the mold cavity before solidifying.
Factors affecting fluidity include:
- Viscosity: Higher viscosity increases internal resistance to flow, decreasing fluidity.
- Surface tension: High surface tension inhibits the molten metal from entering narrow sections, decreasing fluidity.
- Freezing range: A wider freezing range creates a longer mushy (semi-solid) zone containing dendritic structures that impede liquid flow, which decreases fluidity.
- Degree of superheat: The difference between the pouring temperature () and the liquidus temperature () is the degree of superheat:
Increasing the superheat delays the onset of solidification, keeping the metal liquid for a longer duration, which significantly increases fluidity.
Answer: (D) degree of superheat
Practise Casting: Patterns, Moulds, Gating and Solidification
34 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Casting: Patterns, Moulds, Gating and Solidification
- GATE 2019 ME Set 2 · Q60The figure shows a pouring arrangement for casting of a metal block. Frictional losses are negligible. The…
- GATE 2018 ME Set 2 · Q23During solidification of a pure molten metal, the grains in the casting near the mould wall are
- GATE 2018 ME Set 2 · Q60For sand-casting a steel rectangular plate with dimensions 80 mm × 120 mm × 20 mm, a cylindrical riser has…
- GATE 2017 ME Set 1 · Q54A sprue in a sand mould has a top diameter of 20 mm and height of 200 mm. The velocity of the molten metal…
- GATE 2016 ME Set 1 · Q32The part of a gating system which regulates the rate of pouring of molten metal is
- GATE 2016 ME Set 1 · Q59Heat is removed from a molten metal of mass 2 kg at a constant rate of 10 kW till it is completely…
Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.