GATE 2016 ME Set 1 · Question 30
The "Jominy test" is used to find
- A
Young's modulus
- B
hardenability
- C
yield strength
- D
thermal conductivity
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.20 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The Jominy end-quench test is a standardized method used to determine the hardenability of an alloy steel.
In this test:
1. A standard cylindrical specimen of diameter () and length () is austenitized uniformly.
2. It is quickly placed in a fixture and quenched at one end by a controlled jet of water.
3. The cooling rate decreases along the length away from the quenched end.
4. Rockwell C hardness () is measured along flat surfaces ground along the length at regular intervals.
The resulting hardness versus distance curve demonstrates the depth to which the steel can be hardened, which defines its hardenability.
Answer: (B) hardenability
Practise Phase Diagrams and Heat Treatment
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Phase Diagrams and Heat Treatment
- GATE 2016 ME Set 2 · Q31In the phase diagram shown in the figure, four samples of the same composition are heated to temperatures…
- GATE 2016 ME Set 2 · Q58In a binary system of A and B, a liquid of 20% A (80% B) is coexisting with a solid of 70% A (30% B). For an…
- GATE 2014 ME Set 1 · Q34The process of reheating the martensitic steel to reduce its brittleness without any significant loss in its…
- GATE 2014 ME Set 4 · Q34Match the heat treatment processes (Group A) and their associated effects on properties (Group B) of medium…
- GATE 2012 ME · Q4During *normalizing* process of steel, the specimen is heated
- GATE 2025 ME · Q20Among the following surface hardening processes, steel is heated to the lowest temperature in
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.