PARIXO GATE · ME Open the app

GATE 2020 ME Set 1 · Question 32

1 markNumerical answerManufacturing EngineeringSheet Metal Forming Processes

A sheet metal with a stock hardness of 250 HRC has to be sheared using a punch and a die having a clearance of 1 mm between them. If the stock hardness of the sheet metal increases to 400 HRC, the clearance between the punch and the die should be _______ mm.

GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.22 in the ME section

Answer
1 to 1.3

From the official answer key published by IIT Delhi.

Worked solution

In sheet metal shearing and blanking operations, the radial clearance between the punch and die is given by the empirical relationship:

where is the sheet thickness, is the ultimate shear strength of the material, and is an empirical constant.

Since the shear strength of a material is approximately proportional to its hardness (), the required clearance scales as:

Therefore, for the two different hardness levels:

Given , , and :

Rounding to two decimal places gives to , which lies in the accepted official range.

Answer: 1.26

Practise Sheet Metal Forming Processes

9 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Sheet Metal Forming Processes

Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.