GATE 2014 ME Set 2 · Question 65
A rectangular hole of size is to be made on a thick sheet of steel having ultimate tensile strength and shear strength of and , respectively. The hole is made by punching process. Neglecting the effect of clearance, the punching force (in ) is
- A
300
- B
450
- C
600
- D
750
GATE 2014 · Mechanical Engineering · Set 2 · IIT Kharagpur · printed as Q.55 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The maximum force required in a punching operation is given by:
where is the sheared area along the perimeter of the cut and is the shear strength of the sheet metal.
Given:
- Dimensions of the rectangular hole: length , width
- Sheet thickness:
- Shear strength:
- Ultimate tensile strength: (not used directly, as failure occurs purely in shear)
The perimeter of the cut, , is:
The total sheared area is:
Substituting and into the force equation:
Using tensile strength instead of shear strength erroneously gives (Option D).
Answer: (B) 450
Practise Sheet Metal Forming Processes
9 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Sheet Metal Forming Processes
- GATE 2012 ME · Q37Calculate the punch size in mm, for a circular blanking operation for which details are given below. | Size…
- GATE 2026 ME · Q59In a deep drawing operation of a rectangular sheet metal, 30% stretching in length results in 15% reduction…
- GATE 2024 ME · Q29The “Earing” phenomenon in metal forming is associated with
- GATE 2024 ME · Q62A blanking operation is performed on C20 steel sheet to obtain a circular disc having a diameter of 20 mm…
- GATE 2020 ME Set 1 · Q32A sheet metal with a stock hardness of 250 HRC has to be sheared using a punch and a die having a clearance…
- GATE 2018 ME Set 1 · Q46The percentage scrap in a sheet metal blanking operation of a continuous strip of sheet metal as shown in…
Question from the official GATE 2014 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.