GATE 2020 ME Set 2 · Question 51
A steel spur pinion has a module () of , teeth and pressure angle. The pinion rotates at and transmits power to a teeth gear. The face width () is , Lewis form factor and a dynamic factor . The bending stress () induced in a tooth can be calculated by using the Lewis formula given below.
If the maximum bending stress experienced by the pinion is , the power transmitted is _____ *(round off to one decimal place)*.
Lewis formula: , where is the tangential load acting on the pinion.
GATE 2020 · Mechanical Engineering · Set 2 · IIT Delhi · printed as Q.41 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
The pitch diameter of the pinion is:
The pitch line velocity of the pinion rotating at is:
From the given Lewis formula for tooth bending stress:
Rearranging to solve for the tangential load :
The transmitted power is:
Answer: 10.0
Practise Spur & Helical Gears
5 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Spur & Helical Gears
- GATE 2019 ME Set 1 · Q17A spur gear with 20° full depth teeth is transmitting 20 kW at 200 rad/s. The pitch circle diameter of the…
- GATE 2014 ME Set 1 · Q42A pair of spur gears with module 5 mm and a center distance of 450 mm is used for a speed reduction of 5:1.…
- GATE 2014 ME Set 2 · Q50A spur pinion of pitch diameter 50 mm rotates at 200 rad/s and transmits 3 kW power. The pressure angle of…
- GATE 2025 ME · Q59A pair of spur gears is required to maintain a velocity ratio of 1:2. The module of the gears is 10 mm and…
Question from the official GATE 2020 ME paper (Set 2), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.