GATE 2025 ME · Question 59
A pair of spur gears is required to maintain a velocity ratio of . The module of the gears is and the addendum is . If the operating pressure angle is , the minimum number of teeth required on the pinion to ensure NO interference/undercutting is _______ (*answer in integer*).
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
To avoid interference between a pinion and a mating gear, the maximum addendum of the gear must not extend beyond the interference limit point on the pinion. The minimum number of teeth on the pinion is given by:
where:
- Gear ratio
- Addendum coefficient of the gear
- Pressure angle
Substituting the given values:
Evaluating :
To ensure no interference, rounding up to the next integer yields:
Answer: 25
Practise Spur & Helical Gears
5 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Spur & Helical Gears
- GATE 2020 ME Set 2 · Q51A steel spur pinion has a module (m) of 1.25 mm, 20 teeth and 20° pressure angle. The pinion rotates at 1200…
- GATE 2019 ME Set 1 · Q17A spur gear with 20° full depth teeth is transmitting 20 kW at 200 rad/s. The pitch circle diameter of the…
- GATE 2014 ME Set 1 · Q42A pair of spur gears with module 5 mm and a center distance of 450 mm is used for a speed reduction of 5:1.…
- GATE 2014 ME Set 2 · Q50A spur pinion of pitch diameter 50 mm rotates at 200 rad/s and transmits 3 kW power. The pressure angle of…
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.