GATE 2023 ME · Question 40
The figure shows a thin-walled open-top cylindrical vessel of radius and wall thickness . The vessel is held along the brim and contains a constant-density liquid to height from the base. Neglect atmospheric pressure, the weight of the vessel and bending stresses in the vessel walls.
Which one of the plots depicts qualitatively CORRECT dependence of the magnitudes of axial wall stress () and circumferential wall stress () on ?
- A
See figure (A)
- B
See figure (B)
- C
See figure (C)
- D
See figure (D)
GATE 2023 · Mechanical Engineering · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
Let the liquid density be . At depth from the liquid surface (), the gauge pressure is:
1. Circumferential (Hoop) Stress ():
For a thin-walled cylinder of radius and wall thickness :
Thus, varies linearly with depth , with and .
2. Axial Stress ():
The vessel is supported only along the top brim and the weight of the vessel itself is neglected. The liquid exerts a uniform downward hydrostatic pressure on the flat base of area , producing a total downward load:
Because the vertical walls experience no vertical shear traction from the static fluid, this entire downward load is carried in tension across any horizontal cross-section of the cylinder wall ():
Notice that at :
Hence, the constant and linearly increasing intersect precisely at , which matches plot (A).
Answer: (A) See figure (A)
Practise Thin Pressure Vessels
11 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Thin Pressure Vessels
- GATE 2022 ME Set 1 · Q52A thin-walled cylindrical pressure vessel has mean wall thickness of t and nominal radius of r. The…
- GATE 2018 ME Set 2 · Q47A thin-walled cylindrical can with rigid end caps has a mean radius R = 100 mm and a wall thickness of t = 5…
- GATE 2016 ME Set 2 · Q18A thin cylindrical pressure vessel with closed-ends is subjected to internal pressure. The ratio of…
- GATE 2015 ME Set 2 · Q18A gas is stored in a cylindrical tank of inner radius 7 m and wall thickness 50 mm. The gage pressure of the…
- GATE 2015 ME Set 3 · Q27A cylindrical tank with closed ends is filled with compressed air at a pressure of 500 kPa. The inner radius…
- GATE 2014 ME Set 4 · Q41A thin gas cylinder with an internal radius of 100 mm is subject to an internal pressure of 10 MPa. The…
Question from the official GATE 2023 ME paper, IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.