PARIXO GATE · ME Open the app

GATE 2025 ME · Question 42

2 marksMultiple choiceVibrationsEquivalent Stiffness, Mass & Energy Methods

The system shown in the figure below consists of a cantilever beam (with flexural rigidity and negligible mass), a spring (with spring constant and negligible mass) and a block of mass . Assuming a lumped parameter model for the system, the fundamental natural frequency () of the system is

Figure 1 for GATE 2025 ME question 42
  1. A

  2. B

  3. C

  4. D

GATE 2025 · Mechanical Engineering · IIT Roorkee

Answer
(A)

From the official answer key published by IIT Roorkee.

Worked solution

Consider a downward vertical displacement of the mass . Because the tip of the cantilever beam and the lower end of the spring are attached to the mass at the same point, both undergo the same displacement .

The equivalent stiffness of a massless cantilever beam under an end load is:

The stiffness of the helical spring is . Since both elements undergo the same displacement, they act in parallel:

The equation of motion for the lumped mass is:

Therefore, the fundamental natural frequency of the system is:

Answer: (A)

Practise Equivalent Stiffness, Mass & Energy Methods

19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Equivalent Stiffness, Mass & Energy Methods

Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.