GATE 2025 ME · Question 41
A plate of thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of . The plate thickness is to be reduced to in a single pass. Assume no change in width. The process feasibility and the maximum draft (in mm) can be represented, respectively, as
Use the coefficient of friction as
- A
feasible and 3.6
- B
NOT feasible and 2.6
- C
feasible and 3.0
- D
NOT feasible and 6.0
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The condition for bite without an external push in a rolling operation requires the actual draft to not exceed the maximum permissible draft:
where is the coefficient of friction, and the roll radius is:
Substitute the given values:
The required reduction in thickness (draft) is:
Since the required draft , the rolling operation is feasible.
Answer: (A)
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2022 ME Set 1 · Q56A 4 mm thick aluminum sheet of width w = 100 mm is rolled in a two-roll mill of roll diameter 200 mm each.…
- GATE 2021 ME Set 1 · Q50A 200 mm wide plate having a thickness of 20 mm is fed through a rolling mill with two rolls. The radius of…
- GATE 2021 ME Set 2 · Q51The thickness, width and length of a metal slab are 50 mm, 250 mm and 3600 mm, respectively. A rolling…
- GATE 2020 ME Set 1 · Q42A strip of thickness 40 mm is to be rolled to a thickness of 20 mm using a two-high mill having rolls of…
- GATE 2020 ME Set 1 · Q56The thickness of a steel plate with material strength coefficient of 210 MPa, has to be reduced from 20 mm…
- GATE 2020 ME Set 2 · Q32A bolt head has to be made at the end of a rod of diameter d = 12 mm by localized forging (upsetting)…
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.