GATE 2025 ME · Question 43
The endurance limit of a specific grade of steel is same as its yield strength. The ultimate strength of this grade of steel is twice of its yield strength. A component made of this steel is loaded in tension and unloaded periodically. It is required that the component does NOT fail for at least loading cycles, as per the Soderberg law. Considering a factor of safety of 2, the maximum applied tensile principal stress is
- A
one-fourth of the endurance limit
- B
half of the endurance limit
- C
the endurance limit
- D
twice the endurance limit
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
Let the maximum applied tensile principal stress be . The component is loaded in tension and unloaded periodically, so:
The mean stress and alternating stress amplitude are:
According to the Soderberg failure criterion:
Given that the endurance limit equals the yield strength () and the factor of safety is :
Thus, the maximum applied tensile principal stress is half of the endurance limit.
Answer: (B)
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2024 ME · Q26Which one of the following failure theories is the most conservative design approach against fatigue failure?
- GATE 2023 ME · Q18The S-N curve from a fatigue test for steel is shown. Which one of the options gives the endurance limit?
- GATE 2022 ME Set 1 · Q29Which of the following methods can improve the fatigue strength of a circular mild steel (MS) shaft?
- GATE 2021 ME Set 1 · Q64A machine part in the form of cantilever beam is subjected to fluctuating load as shown in the figure. The…
- GATE 2021 ME Set 2 · Q65The figure shows the relationship between fatigue strength (S) and fatigue life (N) of a material. The…
- GATE 2020 ME Set 2 · Q31A machine member is subjected to fluctuating stress σ = σ0 (8π t). The endurance limit of the material is…
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.