GATE 2013 ME · Question 40
A bar is subjected to fluctuating tensile load from to . The material has yield strength of and endurance limit in reversed bending is . According to the Soderberg principle, the area of cross-section in of the bar for a factor of safety of is
- A
- B
- C
- D
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
From the fluctuating load range and :
- Mean force:
- Alternating force:
For cross-sectional area , the mean and alternating stresses are:
According to the Soderberg failure criterion:
Given yield strength , endurance limit , and factor of safety :
Answer: (D)
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2025 ME · Q43The endurance limit of a specific grade of steel is same as its yield strength. The ultimate strength of…
- GATE 2024 ME · Q26Which one of the following failure theories is the most conservative design approach against fatigue failure?
- GATE 2023 ME · Q18The S-N curve from a fatigue test for steel is shown. Which one of the options gives the endurance limit?
- GATE 2022 ME Set 1 · Q29Which of the following methods can improve the fatigue strength of a circular mild steel (MS) shaft?
- GATE 2021 ME Set 1 · Q64A machine part in the form of cantilever beam is subjected to fluctuating load as shown in the figure. The…
- GATE 2021 ME Set 2 · Q65The figure shows the relationship between fatigue strength (S) and fatigue life (N) of a material. The…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.