GATE 2021 ME Set 1 · Question 64
A machine part in the form of cantilever beam is subjected to fluctuating load as shown in the figure. The load varies from to . The modified endurance, yield and ultimate strengths of the material are , and , respectively.
The factor of safety of the beam using modified Goodman criterion is ________ *(round off to one decimal place)*.
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.54 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
For the cantilever beam of length , the load fluctuates between and .
The maximum and minimum bending moments at the fixed base are:
The mean and alternating bending moments are:
The section modulus for the cross-section (, ) is:
The corresponding mean and alternating stresses are:
Using the modified Goodman criterion:
Answer: 2
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2021 ME Set 2 · Q65The figure shows the relationship between fatigue strength (S) and fatigue life (N) of a material. The…
- GATE 2020 ME Set 2 · Q31A machine member is subjected to fluctuating stress σ = σ0 (8π t). The endurance limit of the material is…
- GATE 2019 ME Set 1 · Q32During a high cycle fatigue test, a metallic specimen is subjected to cyclic loading with a mean stress of…
- GATE 2019 ME Set 2 · Q18Endurance limit of a beam subjected to pure bending decreases with
- GATE 2018 ME Set 2 · Q31Fatigue life of a material for a fully reversed loading condition is estimated from σa = 1100 N-0.15, where…
- GATE 2018 ME Set 2 · Q48A bar is subjected to a combination of a steady load of 60 kN and a load fluctuating between -10 kN and 90…
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.