GATE 2021 ME Set 2 · Question 65
The figure shows the relationship between fatigue strength () and fatigue life () of a material. The fatigue strength of the material for a life of is , while its fatigue strength for a life of is .
The life of a cylindrical shaft made of this material subjected to an alternating stress of will then be \_\_\_\_\_\_\_\_\_\_\_ cycles *(round off to the nearest integer)*.
GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.55 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
The - curve on a versus plot is linear in the finite life region (), governed by the power law relation:
The slope of the line is:
Given at and at :
For an alternating stress , the corresponding fatigue life is obtained using:
Answer: 163842 (acceptable range: 152000 to 165000)
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2020 ME Set 2 · Q31A machine member is subjected to fluctuating stress σ = σ0 (8π t). The endurance limit of the material is…
- GATE 2019 ME Set 1 · Q32During a high cycle fatigue test, a metallic specimen is subjected to cyclic loading with a mean stress of…
- GATE 2019 ME Set 2 · Q18Endurance limit of a beam subjected to pure bending decreases with
- GATE 2018 ME Set 2 · Q31Fatigue life of a material for a fully reversed loading condition is estimated from σa = 1100 N-0.15, where…
- GATE 2018 ME Set 2 · Q48A bar is subjected to a combination of a steady load of 60 kN and a load fluctuating between -10 kN and 90…
- GATE 2017 ME Set 1 · Q43A machine element has an ultimate strength (σu) of 600 N/mm2, and endurance limit (σen) of 250 N/mm2. The…
Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.