GATE 2013 ME · Question 48
Common Data for Questions 48 and 49:
A single riveted lap joint of two similar plates as shown in the figure below has the following geometrical and material details.
width of the plate , thickness of the plate , number of rivets , diameter of the rivet , diameter of the rivet hole , allowable tensile stress of the plate , allowable shear stress of the rivet and allowable bearing stress of the rivet .
If the rivets are to be designed to avoid crushing failure, the maximum permissible load in is
- A
7.50
- B
15.00
- C
22.50
- D
30.00
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
The crushing (or bearing) resistance of a riveted joint depends on the projected contact area of the rivets bearing against the plate thickness.
For rivets, the projected bearing area is:
where:
- (number of rivets)
- (nominal diameter of the rivet)
- (thickness of the plate)
Substituting the given values:
The maximum permissible load to avoid crushing failure with allowable bearing stress is:
Answer: (C) 22.50
Practise Riveted & Bolted Joints
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Riveted & Bolted Joints
- GATE 2013 ME · Q49Common Data for Questions 48 and 49: A single riveted lap joint of two similar plates as shown in the figure…
- GATE 2022 ME Set 1 · Q18A square threaded screw is used to lift a load W by applying a force F. Efficiency of square threaded screw…
- GATE 2022 ME Set 1 · Q40A bracket is attached to a vertical column by means of two identical rivets U and V separated by a distance…
- GATE 2020 ME Set 1 · Q49A rectangular steel bar of length 500 mm, width 100 mm, and thickness 15 mm is cantilevered to a 200 mm…
- GATE 2018 ME Set 2 · Q18Pre-tensioning of a bolted joint is used to
- GATE 2017 ME Set 1 · Q19Consider the schematic of a riveted lap joint subjected to tensile load F, as shown below. Let d be the…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.