GATE 2014 ME Set 2 · Question 20
In a structure subjected to fatigue loading, the minimum and maximum stresses developed in a cycle are and respectively. The value of stress amplitude (in ) is _______
GATE 2014 · Mechanical Engineering · Set 2 · IIT Kharagpur · printed as Q.10 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In cyclic fatigue loading, the stress varies between a minimum stress and a maximum stress .
The given values are:
The stress amplitude (alternating stress) is defined as half of the stress range:
Substituting the given values:
Answer: 100
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2014 ME Set 3 · Q16A rotating steel shaft is supported at the ends. It is subjected to a point load at the center. The maximum…
- GATE 2013 ME · Q40A bar is subjected to fluctuating tensile load from 20 kN to 100 kN. The material has yield strength of 240…
- GATE 2025 ME · Q43The endurance limit of a specific grade of steel is same as its yield strength. The ultimate strength of…
- GATE 2024 ME · Q26Which one of the following failure theories is the most conservative design approach against fatigue failure?
- GATE 2023 ME · Q18The S-N curve from a fatigue test for steel is shown. Which one of the options gives the endurance limit?
- GATE 2022 ME Set 1 · Q29Which of the following methods can improve the fatigue strength of a circular mild steel (MS) shaft?
Question from the official GATE 2014 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.