PARIXO GATE · ME Open the app

GATE 2014 ME Set 3 · Question 16

1 markNumerical answerMachine DesignDesign for Dynamic Loading & Fatigue

A rotating steel shaft is supported at the ends. It is subjected to a point load at the center. The maximum bending stress developed is 100 MPa. If the yield, ultimate and corrected endurance strength of the shaft material are 300 MPa, 500 MPa and 200 MPa, respectively, then the factor of safety for the shaft is ________

GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.6 in the ME section

Answer
1.9 to 2.1

From the official answer key published by IIT Kharagpur.

Worked solution

A rotating shaft carrying a steady transverse point load experiences completely reversed bending stress. Therefore, for each fiber of the shaft, the stress alternates between tensile and compressive values of equal magnitude:

The mean stress () and alternating stress amplitude () are:

Given the corrected endurance limit , yield strength , and ultimate strength . Since , all standard fatigue criteria (Soderberg, Goodman, Gerber) simplify to:

Solving for the factor of safety :

Answer: 2

Practise Design for Dynamic Loading & Fatigue

19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Design for Dynamic Loading & Fatigue

Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.