GATE 2014 ME Set 4 · Question 33
Better surface finish is obtained with a large rake angle because
- A
the area of shear plane decreases resulting in the decrease in shear force and cutting force
- B
the tool becomes thinner and the cutting force is reduced
- C
less heat is accumulated in the cutting zone
- D
the friction between the chip and the tool is less
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.23 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
According to Merchant's circle analysis, the shear plane angle is related to the orthogonal rake angle and friction angle by:
As the rake angle increases, the shear plane angle increases. The area of the shear plane is given by:
where is the width of cut and is the uncut chip thickness.
An increase in results in a larger value of , thereby decreasing the shear plane area . Consequently, the shear force and the primary cutting force are significantly reduced. This reduction in forces minimizes chatter, prevents built-up edge (BUE) formation, and leads to a smoother surface finish.
Answer: (A) the area of shear plane decreases resulting in the decrease in shear force and cutting force
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2013 ME · Q52Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2013 ME · Q53Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2012 ME · Q27Details pertaining to an orthogonal metal cutting process are given below. | | | |---|---| | Chip thickness…
- GATE 2026 ME · Q63During orthogonal turning by using a single point cutting tool, feed rate is 0.24 mm/rev. The uncut chip…
- GATE 2023 ME · Q44In an ideal orthogonal cutting experiment (see figure), the cutting speed V is 1 m/s, the rake angle of the…
- GATE 2022 ME Set 1 · Q54Under orthogonal cutting condition, a turning operation is carried out on a metallic workpiece at a cutting…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.