GATE 2014 ME Set 4 · Question 34
Match the heat treatment processes (Group A) and their associated effects on properties (Group B) of medium carbon steel
| Group A | Group B |
| :--- | :--- |
| P: Tempering | I: Strengthening and grain refinement |
| Q: Quenching | II: Inducing toughness |
| R: Annealing | III: Hardening |
| S: Normalizing | IV: Softening |
- A
P-III, Q-IV, R-II, S-I
- B
P-II, Q-III, R-IV, S-I
- C
P-III, Q-II, R-IV, S-I
- D
P-II, Q-III, R-I, S-IV
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.24 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The standard heat treatment processes for medium carbon steels correspond to specific metallurgical changes:
1. Tempering (P): Performed after quenching to relieve internal stresses, reduce extreme brittleness, and impart toughness (Match: II).
2. Quenching (Q): Rapid cooling from the austenitizing temperature to form martensite, resulting in maximum hardness (Match: III).
3. Annealing (R): Heating and slow furnace cooling to produce a coarse pearlitic structure, thereby softening the material and relieving residual stresses (Match: IV).
4. Normalizing (S): Heating above the upper critical temperature followed by still-air cooling to produce a fine and uniform pearlite grain structure, enhancing strength and refining grains (Match: I).
Thus, the correct matching is P-II, Q-III, R-IV, S-I.
Answer: (B) P-II, Q-III, R-IV, S-I
Practise Phase Diagrams and Heat Treatment
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Phase Diagrams and Heat Treatment
- GATE 2012 ME · Q4During *normalizing* process of steel, the specimen is heated
- GATE 2025 ME · Q20Among the following surface hardening processes, steel is heated to the lowest temperature in
- GATE 2024 ME · Q28The phases present in pearlite are
- GATE 2023 ME · Q52A steel sample with 1.5 wt.% carbon (no other alloying elements present) is slowly cooled from 1100 °C to…
- GATE 2022 ME Set 1 · Q27Which of the following heat treatment processes is/are used for surface hardening of steels?
- GATE 2022 ME Set 1 · Q41In Fe-Fe3C phase diagram, the eutectoid composition is 0.8 weight % of carbon at 725 °C. The maximum…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.