GATE 2014 ME Set 4 · Question 43
It is desired to avoid interference in a pair of spur gears having a pressure angle. With increase in pinion to gear speed ratio, the minimum number of teeth on the pinion
- A
increases
- B
decreases
- C
first increases and then decreases
- D
remains unchanged
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.33 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The minimum number of teeth on the pinion to avoid interference with a mating gear is given by:
where is the speed ratio (gear ratio), is the addendum fraction of the gear, and is the pressure angle.
As the speed ratio increases from (equal gears) towards (pinion meshing with a rack):
- For and ,
- For (rack cutter limit),
Thus, with an increase in the pinion-to-gear speed ratio, the minimum number of teeth on the pinion increases.
Answer: (A) increases
Practise Gears and Gear Trains
20 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Gears and Gear Trains
- GATE 2013 ME · Q32A compound gear train with gears P, Q, R and S has number of teeth 20, 40, 15 and 20, respectively. Gears Q…
- GATE 2012 ME · Q8The following are the data for two crossed helical gears used for speed reduction: Gear I : Pitch circle…
- GATE 2026 ME · Q17A gear train with five gears is shown in the figure below. The number of teeth on each gear is N1, N2, N3,…
- GATE 2026 ME · Q22Worm gearsets are used for transmitting rotary motion between
- GATE 2024 ME · Q52The Levai type-A train illustrated in the figure has gears with module m = 8 mm/tooth. Gears 2 and 3 have 19…
- GATE 2023 ME · Q29Two meshing spur gears 1 and 2 with diametral pitch of 8 teeth per mm and an angular velocity ratio…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.