GATE 2015 ME Set 1 · Question 16
Consider fully developed flow in a circular pipe with negligible entrance length effects. Assuming the mass flow rate, density and friction factor to be constant, if the length of the pipe is doubled and the diameter is halved, the head loss due to friction will increase by a factor of
- A
- B
- C
- D
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The Darcy-Weisbach equation for head loss due to friction in a pipe is:
Expressing the mean velocity in terms of mass flow rate and diameter :
Substituting into the head loss equation:
Since mass flow rate , density , and friction factor are constant:
Given that the length is doubled () and the diameter is halved ():
Thus, the head loss increases by a factor of .
Answer: (D)
Practise Flow through pipes
7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Flow through pipes
- GATE 2015 ME Set 3 · Q32Three parallel pipes connected at the two ends have flow-rates Q1, Q2 and Q3 respectively, and the…
- GATE 2012 ME · Q5Oil flows through a 200 mm diameter horizontal cast iron pipe (friction factor, f = 0.0225) of length 500 m.…
- GATE 2024 ME · Q37In the pipe network shown in the figure, all pipes have the same cross-section and can be assumed to have…
- GATE 2020 ME Set 2 · Q59Water (density 1000 kg/m3) flows through an inclined pipe of uniform diameter. The velocity, pressure and…
- GATE 2017 ME Set 1 · Q8Water (density = 1000 kg/m3) at ambient temperature flows through a horizontal pipe of uniform cross section…
- GATE 2017 ME Set 1 · Q31Consider steady flow of an incompressible fluid through two long and straight pipes of diameters d1 and d2…
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.