GATE 2017 ME Set 1 · Question 8
Water (density ) at ambient temperature flows through a horizontal pipe of uniform cross section at the rate of . If the pressure drop across the pipe is , the minimum power required to pump the water across the pipe, in watts, is ________
GATE 2017 · Mechanical Engineering · Set 1 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The minimum power required to pump fluid against a pressure drop is given by:
where is the volumetric flow rate and is the pressure drop across the pipe.
The volumetric flow rate is related to the mass flow rate and fluid density by:
Given , the required pumping power is:
Answer: 100
Practise Flow through pipes
7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Flow through pipes
- GATE 2017 ME Set 1 · Q31Consider steady flow of an incompressible fluid through two long and straight pipes of diameters d1 and d2…
- GATE 2015 ME Set 1 · Q16Consider fully developed flow in a circular pipe with negligible entrance length effects. Assuming the mass…
- GATE 2015 ME Set 3 · Q32Three parallel pipes connected at the two ends have flow-rates Q1, Q2 and Q3 respectively, and the…
- GATE 2012 ME · Q5Oil flows through a 200 mm diameter horizontal cast iron pipe (friction factor, f = 0.0225) of length 500 m.…
- GATE 2024 ME · Q37In the pipe network shown in the figure, all pipes have the same cross-section and can be assumed to have…
- GATE 2020 ME Set 2 · Q59Water (density 1000 kg/m3) flows through an inclined pipe of uniform diameter. The velocity, pressure and…
Question from the official GATE 2017 ME paper (Set 1), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.